Did you perform the Instrument Cluster System Check?

--

Go to Step 2

Go to Diagnostic System Check - Instrument Cluster

1. Connect a scan tool.
2. While observing the status of the reset switch press the FEIC Reset switch.

Does the FEIC Reset data change from OFF to ON?

--

Go to Step 3

Go to Step 4

1. Drive the vehicle.
2. Place the DIC display in Average Fuel Economy.
3. Press FEIC Reset switch.

Does the display reset?

--

Go to Diagnostic System Check - Instrument Cluster

Go to Step 10

1. Turn the ignition switch to the OFF position.
2. Disconnect the DIC Display switch assembly IP Switch Replacement .
3. Turn the ignition switch to the ON position.
4. Using a DMM test for voltage at terminal 1 circuit 1816 ORN.

Is the measured voltage same as the specified value?

B+

Go to Step 5

Go to Step 7

Using a DMM, test terminal 2 circuit 1550 BLK for an open.

Is circuit 1550 open?

--

Go to Step 8

Go to Step 6

1. Using scan tool, read FEIC Reset.
2. Using a fused 3-amp jumper wire, jumper terminals 1 and 2 of the DIC switch harness connector.

Does the FEIC Reset data change from off to on?

--

Go to Step 9

Go to Step 10

Repair open or poor connection in circuit 1816 ORN.

Did you complete the repair and test the system?

--

Go to Diagnostic System Check - Instrument Cluster

--

Repair open or loose terminal in circuit 1550 BLK.

Did you complete the repair and test the system?

--

Go to Diagnostic System Check - Instrument Cluster

--

Replace the DIC switch assembly.

Did you complete the repair and test the system?

--

Go to Diagnostic System Check - Instrument Cluster

--

Replace the IP cluster. Refer to Instrument Cluster Replacement .

Is the repair complete?

--

Go to Diagnostic System Check - Instrument Cluster

--