Ignition and Key Alarm Switch Assembly - Disassemble - Off Vehicle Floor Shift
- Remove the upper and lower trim covers. Refer to
Steering Column Trim Covers - Disassemble - Off Vehicle
.
- Remove the wire harness
strap (2) from the steering column and the wire harness
assembly (1).
- Slide the 2 connectors (2)
of the turn signal and multifunction switch assembly out of the bulkhead connector (1).
- Remove the key alarm connector (1)
from the electronic lock module assembly (2).
4.1. | Rotate the key alarm connector (1) 90 degrees. |
4.2. | Pull the key alarm connector (1) out of the electronic
lock module assembly (2). |
- Remove the connector (2)
from the electric park lock (3).
- Remove the TORX® head screw (1) from the electric park
lock (3).
- Remove the 2 tapping
screws (2) from the ignition and key alarm switch assembly (1).
- Remove the ignition and key alarm switch assembly (1) from
the electronic lock module assembly.
Ignition and Key Alarm Switch Assembly - Disassemble - Off Vehicle Column Shift
- Remove the upper and lower trim covers. Refer to
Steering Column Trim Covers - Disassemble - Off Vehicle
.
- Remove the wire harness
strap (2) from the steering column and the wire harness assembly (1).
- Slide the 2 connectors (2)
of the turn signal and multifunction switch assembly out of the bulkhead connector (1).
- Remove the key alarm connector (1)
from the electronic lock module assembly (2).
4.1. | Rotate the key alarm connector (1) 90 degrees. |
4.2. | Pull the key alarm connector (1) out of the electronic
lock module assembly (2). |
- Remove the 2 tapping
screws (2) from the ignition and key alarm switch assembly (1).
- Remove the ignition and key alarm switch assembly (1) from
the electronic lock module assembly.