Removal Procedure
- Remove the left instrument panel insulator. Refer to
Instrument Panel Insulator Replacement
in Instrument Panel
Gauges and Console.
- Remove the instrument
panel driver knee bolster. Refer to
Knee Bolster Replacement
in Instrument Panel Gauges and Console.
- Remove the vacuum lines from the mode actuator.
- Carefully rotate the mode
actuator towards the front of the vehicle until the actuator is released from
the mounting pins on the HVAC control module.
- Disconnect the vacuum
actuator pushrod from the mode door lever and remove the actuator.
Installation Procedure
- Connect the vacuum actuator
pushrod from the mode door lever and position the actuator.
- Carefully rotate the mode
actuator towards the rear of the vehicle until the actuator is engaged on
the mounting pins on the HVAC control module.
- Install the instrument
panel driver knee bolster. Refer to
Knee Bolster Replacement
in Instrument Panel Gauges and Console.
- Install the left side instrument panel insulator. Refer to
Instrument Panel Insulator Replacement
in Instrument Panel
Gauges and Console.