Tools Required
J 39916-A CD and Cassette
Diagnostic Kit
Important: Always compare the front speakers to the front, and compare the rear
speakers to the rear. Do not compare the front speaker to the rear speaker
for the following reasons:
| • | The front and the rear speakers could be different speakers. |
| • | The front and the rear speaker mounting environments could cause
a sound difference. |
The tones test and evaluate the following components:
| • | Other complex speaker systems |
Three basic tones are used:
The combination tone is a blend of the above 3 tones.
Bass/Sub-Woofer Test (50 Hz Sine Tone)
The 50 Hz sine tone evaluates the following items:
| • | The bass response of an audio system |
| • | Audio systems that have separate sub-woofer amplifiers and speakers |
Midrange Speaker Test (500 Hz Warble Tone)
The 500 Hz warble tone evaluates the midrange speaker response.
The 500 Hz warble tone qualifies as a warble tone because of the different
audio characteristics present as opposed to the sine tone. The 500 Hz
warble tone produces a warble sound. At midrange frequencies, use a warble
tone instead of a sine tone because the location of a warble tone source,
such as a speaker, is easier to identify. A normal sine tone can set up a
standing wave within a vehicle. A standing wave may cause difficulty in determining
the source location.
Tweeter Test (9 kHz Spectral Tone)
The 9 kHz spectral tone is used for the following evaluations:
The 9 kHz spectral tone is a section of frequencies of equal
amplitudes ranging from 8.5-9.5 kHz. The tone sounds like a group
of crickets chirping.
The 9 kHz spectral tone is used for 2 reasons:
| • | In order to locate the source, much like the warble tone. |
| • | For easier identification, for those people with high end hearing
loss problems. |
All Speaker Test
The combination tone is used for numerous audio problems, such as the
following conditions:
| • | Distorted sound from the speakers |
| • | No sound from the speakers |
When using the combination tone, comparative AC voltage measurements
can be made on the speaker terminals provided that the following controls
are in the detent position:
With these voltage measurements, a determination can be made in the
diagnosis of the following components:
Speaker/Grill Rattle Test (50 Hz-8 kHz Swept Sine)
The next portion of the diagnostic tape rattles in the following components:
The first test is 2 tones played back-to-back. The second test
is a variable frequency tone, but frequency change is at a much slower rate.
Both tests can be used in order to repair the following conditions:
If the condition has already been identified, complete the following
steps:
| • | Set the following controls to the proper location: |
| • | Play the test tones in the specific problem area. |
Motor Speed Test
A 2-minute time period is marked in this section of tape for the purpose
of inspecting the cassette tape motor speed. This portion of the diagnostic
tape can be used to verify complaints of abnormal sound from the cassette
tape player. In some cases, improper tape motor speed can cause audio abnormalities.
If the time taken for the motor speed test is between 116-121 seconds,
the tape motor speed is within tolerance.
Noise Diagnosis (Dead Space)
This portion can be used for diagnosis such as alternator whine and
switch pops, which can be more easily detected during dead space. Dead space
is blank space between songs. This portion of the diagnostic kit may be
used in conjunction with the noise diagnosis in Radio in Electrical Diagnosis.
