Did you perform the Instrument Cluster Diagnostic System Check?

--

Go to Step 2

Go to Diagnostic System Check - Instrument Cluster

1. Connect a scan tool.
2. While observing the status of the mode switch, press the FEIC Mode switch.

Does the FEIC Mode data change?

--

Go to Diagnostic System Check - Instrument Cluster

Go to Step 3

1. Turn the ignition switch to the OFF position.
2. Disconnect the DIC display switch assembly.
3. Turn the ignition switch to the ON position.
4. Using a DMM, test for voltage at terminal 3 circuit 893 (PNK).

Is the measured voltage the same as the specified value?

B+

Go to Step 4

Go to Step 6

Using a DMM, test terminal 2 circuit 1550 (BLK) for an open.

Is circuit 1550 open?

--

Go to Step 7

Go to Step 5

1. Using scan tool, read FEIC Reset.
2. Using a fused 3-amp jumper wire, jumper terminals 3 and 2 of the DIC switch harness connector.

Does the FEIC Mode data change ?

--

Go to Step 8

Go to Step 9

Repair open or poor connection in circuit 893 (PNK).

Did you complete the repair and test the system?

--

Go to Diagnostic System Check - Instrument Cluster

--

Repair open or loose terminal in circuit 1550 (BLK).

Did you complete the repair and test the system?

--

Go to Diagnostic System Check - Instrument Cluster

--

Replace the DIC switch assembly.

Did you complete the repair and test the system?

--

Go to Diagnostic System Check - Instrument Cluster

--

Replace the IP cluster. Refer to Instrument Cluster Replacement .

Is the repair complete?

--

Go to Diagnostic System Check - Instrument Cluster

--