Tools Required

J 36660-A Torque Angle Meter

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.



2. Remove the ABS electrical connector from the wheel speed sensor (1).



3. Disconnect the trailing arm (1) from the knuckle.



4. Disconnect the trailing arm from the trailing arm bracket (1).



5. Remove the trailing arm (1).

1. Connect the trailing arm (1) to the trailing arm bracket (2).




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the bracket bolt and nut.

Tighten
Tighten the bracket nut to 105 N·m (77 lb ft).




3. Connect the trailing arm to the knuckle.

Tighten
Tighten the trailing arm to knuckle nut to 260 N·m (192 lb ft).




4. Connect the ABS electrical connector from the wheel speed sensor (1).
5. Lower the vehicle.