The traction control switch is a momentary switch. The signal circuit of the traction control switch is grounded when the driver presses the traction control switch. The traction control system will change state from traction on to traction off or from traction off to traction on each time the traction control switch is pressed.
• | The battery voltage is between 9.0 volts and 16.0 volts. |
• | The park brake is not applied. |
• | The signal circuit voltage of the traction control switch is no more than 2.0 volts. |
• | All of the above conditions are present for greater than 60 seconds. |
• | The BCM stores DTC B2747 in memory. |
• | The traction control switch input is ignored until the fault is no longer current. |
• | A current DTC B2747 will clear if the BCM no longer detects a short to ground for longer than 60 seconds. |
• | A history DTC B2747 will clear after 100 consecutive ignition cycles if the condition for the malfunction is no longer present. |
• | A scan tool may be used to clear the DTC. |
Check for a traction control switch that may be sticking in the pressed position. For an intermittent condition refer to Testing for Intermittent Conditions and Poor Connections .
The number(s) below refer to the step number(s) on the diagnostic table.
Step | Action | Value(s) | Yes | No |
---|---|---|---|---|
1 | Did you perform the ABS Diagnostic System Check? | -- | Go to Step 2 | |
Does the scan tool display Active? | -- | Go to Step 3 | Go to Diagnostic Aids | |
Does the scan tool display Inactive? | -- | Go to Step 6 | Go to Step 4 | |
4 | Test the traction control switch input/signal circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 9 | Go to Step 5 |
5 | Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 9 | Go to Step 7 |
6 | Inspect for poor connections at the harness connector of the traction control switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 9 | Go to Step 8 |
7 | Replace the BCM. Refer to Body Control Module Replacement in Body Control System. Important: Perform the set up procedure for the Body Control Module. Refer to Body Control Module (BCM) Programming/RPO Configuration in Body Control System. Did you complete the replacement? | -- | Go to Step 9 | -- |
8 | Replace the traction control switch. Refer to Electronic Traction Control Switch Replacement in Instrument Panel, Gauges and Console. Did you complete the replacement? | -- | Go to Step 9 | -- |
9 |
Does the DTC reset? | -- | Go to Step 2 | System OK |