GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2001 🢒 Regal 🢒 Body and Accessories 🢒 Doors 🢒 Rear Side Door Adjustment

Up/Down or In/Out Adjustment

    Important: The door side upper and lower hinge bolts must remain tight enough to retain door adjusted position


    Object Number: 656127 Size: SH
  1. Loosen the 13 mm door side upper and lower hinge bolts. Do not remove the bolts.
  2. Adjust the door up or down by repositioning the door as needed.
  3. Adjust the door in or out by repositioning the door as needed.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Tighten the 13 mm door side upper and lower hinge bolts.

    5. Tighten
    Tighten the door side hinge bolts to 33 N·m (24 lb ft).

Fore/Aft Adjustment

    Object Number: 308475 Size: SH
  1. Loosen the two 13 mm body side upper and lower hinge bolts (1). Do not remove them.

    2. Object Number: 308476 Size: SH
  2. Loosen the 10 mm cone adjuster body side hinge bolt (1).
  3. Adjust the door fore and aft by repositioning the door as needed.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the one 10 mm cone adjuster (1) body side hinge bolt.

    5. Tighten
    Tighten the cone adjuster body side hinge bolt to 10 N·m (89 lb in).


    Object Number: 308475 Size: SH
  5. Apply Locktite® Blue GM P/N 12345382, or Canadian P/N 10953489, or equivalent prior to installing the body side hinge bolts.
  6. Install two 13 mm body side hinge bolts (1).

    7. Tighten
    Tighten the body side hinge bolts to 33 N·m (24 lb ft).