GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 39194 Oxygen Sensor Wrench

Notice: The Heated Oxygen Sensor (HO2S) and the Oxygen Sensor use a permanently attached pigtail and connector. Do not remove this pigtail from the Heated Oxygen Sensor. Damage or the removal of the pigtail or the connector could affect the proper operation of the sensor.

Take care when handling the HO2S and the O2S. Keep the in-line electrical connector and the louvered end free of grease, dirt, or other contaminants. Also avoid using cleaning solvents of any type. Do not drop the HO2S or the O2S. Do not roughly handle the HO2S or the O2S.

Bank 1 Sensor 2 Removal Procedure

Important: The HO2S may be difficult to remove when engine temperature is less than 48°C (120°F). Excessive force may damage the threads in the exhaust manifold or the exhaust pipe.

  1. Turn OFF the ignition switch.
  2. Caution: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.

  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

  4. Object Number: 402074  Size: SH
  5. Remove the HO2S electrical connector retaining tab (1) from the HO2S electrical connector (2).
  6. Disconnect the HO2S connector from the HO2S electrical connector (2).
  7. Important: Remove HO2S with the engine temperature above 48°C (120°F). Otherwise the HO2S may be difficult to remove.

  8. Remove the HO2S (4) from the exhaust pipe using the J 39194 .

Bank 1 Sensor 2 Installation Procedure


    Object Number: 402074  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

    Important: A special anti-seize compound is used on the HO2S threads. New service sensors should already have the compound applied to the threads. Coat the threads of a reused sensor with anti-seize compound P/N 5613695 or equivalent.

  1. Install the HO2S (4) into the exhaust pipe.
  2. Tighten
    Tighten the HO2S to 41 N·m (30 lb ft).

  3. Connect the HO2S (4) connector to the HO2S electrical connector (2).
  4. Reinstall the retaining tab (1) into the HO2S electrical connector.
  5. Lower the vehicle.