Tools Required

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
2. Remove the drive belt. Refer to Drive Belt Replacement .
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
4. Remove the right front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.



5. Remove the right engine splash shield.
6. Remove the torque converter cover. Refer to Torque Converter Cover Replacement in Automatic Transaxle-4T65-E.



7. Install the J 37096 to hold the flywheel.



8. Remove the crankshaft balancer retaining bolt.




Important: Do not separate the crankshaft pulley from the crankshaft balancer. Service the crankshaft pulley and the crankshaft balancer as an assembly.

9. Install the J 38197-A .
10. Remove the crankshaft balancer.
11. Remove the J 38197-A .

1. Coat the engine front cover seal contact area on the crankshaft balancer, and the seal surface with engine oil.



2. Install the crankshaft balancer.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the crankshaft balancer retaining bolt. Use the J 37096 to keep the flywheel from turning.

Tighten
Tighten the crankshaft balancer bolt to 150 N·m (111 lb ft). Use the J 36660-A in order to rotate the bolt an additional 76 degrees.




4. Remove the J 37096 .
5. Install the torque converter cover. Refer to Torque Converter Cover Replacement in Automatic Transaxle-4T65-E.



6. Install the right engine splash shield and the engine splash shield retainers.
7. Install the right front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
8. Lower the vehicle.
9. Install the drive belt. Refer to Drive Belt Replacement .
10. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
11. Perform the CKP system variation learn procedure. Refer to Crankshaft Position System Variation Learn in Engine Controls - 3.8L.