GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2002 🢒 Regal 🢒 Engine 🢒 Engine Electrical 🢒 Headlamp Switch Replacement

Removal Procedure
  1. Pull the rearward edge of the access opening cover outboard on the left side of the instrument panel (I/P) to release the retainers. Use a plastic flat-bladed tool as an aid if necessary.
  2. Release the forward edge of the access opening cover from behind the hinge pillar and remove the cover.

    3. Object Number: 506429 Size: SH
  3. Remove the headlamp switch screws.

    4. Object Number: 468735 Size: SH
  4. Carefully pull the headlamp switch outboard away from the I/P to access the electrical connector.
  5. Disconnect the electrical connector from the headlamp switch.

Installation Procedure

    Object Number: 468735 Size: SH
  1. Connect the electrical connector to the headlamp switch.
  2. Align the headlamp switch tabs to the I/P and press the switch into position.

    3. Object Number: 506429 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the headlamp switch screws.

    4. Tighten
    Tighten the screws to 1.8 N·m (16 lb in).

  4. Align and insert the forward edge of the left I/P access opening cover behind the hinge pillar.
  5. Align the access opening cover retainers to the slots on the I/P trim pad and press firmly to secure.