Removal Procedure
- Remove the right side instrument panel insulator. Refer to Instrument Panel Insulator Panel Replacement - Right Side in Instrument Panel, Gages and Console.
- Disconnect the electrical connector from the vacuum control assembly.
- Disconnect the vacuum harness connector from the vacuum control assembly.
- Remove the mounting screws from the vacuum control assembly.
- Remove the vacuum control assembly.
Important: Pull the vacuum control assembly straight down to release the tab from the slot in the HVAC module case.
Installation Procedure
- Align the tab to the slot in the HVAC module case, then push up to seat the vacuum control assembly.
- Install the mounting screws to the vacuum control assembly.
- Connect the vacuum harness connector to the vacuum control assembly.
- Connect the electrical connector to the vacuum control assembly.
- Install the right side instrument panel insulator. Refer to Instrument Panel Insulator Panel Replacement - Right Side in Instrument Panel, Gages and Console.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 1.5 N·m (13 lb in).
