- Clean the crankshaft balancer (1).
- Clean the belt grooves of all dirt or debris with a wire brush.
Warning: Refer to Safety Glasses Warning in the Preface section.
- Dry the crankshaft balancer with compressed air.
- Inspect the crankshaft balancer for the following:
| • | Worn, grooved, or damaged hub seal surface |
| • | A crankshaft balancer hub seal surface with excessive scoring, grooves, rust or other damage must be replaced. |
| | Note: In order for the belt to track properly, the belt grooves should be free of all dirt or debris.
|
| • | Dirty or damaged belt grooves |
| | The balancer belt grooves should be free of any nicks, gouges, or other damage that may not allow the belt to track properly. |
| • | Minor imperfections may be removed with a fine file. |
| • | Worn, chunking or deteriorated rubber between the hub and pulley |
