Preliminary Procedures

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.

1

Rear Suspension Link Inner Fastener

Caution: Refer to Fastener Caution in the Preface section.

Procedure

Apply torque on the nut.

Tighten
150 N·m (111 lb ft)

2

Rear Suspension Link Outer Fastener

Procedure

Install a NEW bolt.

Tighten
150 N·m (111 lb ft) + 60 degrees + 15 degrees

3

Adjust Link

Procedure

1. Use a proper jack stand to load the knuckle when tightening the fasteners.
2. After installation, check the rear alignment. Refer to Wheel Alignment Measurement.