Diagnostic Instructions

DTC Descriptor

DTC B3843 02: Outside Air Quality Sensor Circuit Short to Ground

DTC B3843 05: Outside Air Quality Sensor Circuit Short to Battery or Open

DTC B3843 08: Outside Air Quality Sensor Circuit Invalid Signal

Diagnostic Fault Information

Circuit	Short to Ground	Open/High Resistance	Short to Voltage	Signal Performance
Air Quality Sensor Ignition	--	B3843 05	--	--
Air Quality Sensor Signal	B3843 02	B3843 05	B3843 05	B3843 08
Air Quality Sensor Ground	--	B3843 05	--	--

Circuit/System Description

The HVAC control module detects exhaust gas by an air quality sensor. The air quality sensor is a 3-wire sensor with an ignition voltage circuit, a ground circuit and a signal circuit.

The information is pulse width modulation (PWM) signal generated on the output pin.

The HVAC control module evaluates the information of the air quality sensor and closes the recirculation flap while in the automatic mode as soon as the concentration of pollutants exceeds a preset value.

Conditions for Running the DTC

Conditions for Setting the DTC

B3843 02

No PWM is detected and the signal is low.

B3843 05

No PWM is detected and the signal is high.

B3843 08

The Sensor sends a 5% PWM signal indicating an internal sensor short circuit or open circuit.

Action Taken When the DTC Sets

The automatic recirculation mode is disabled.

Conditions for Clearing the DTC

The condition for setting the DTC is no longer present.

Reference Information

Schematic Reference

LINK 49327

Connector End View Reference

Component Connector End Views

Description and Operation

Automatic HVAC Description and Operation

Electrical Information Reference

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

1. Verify that DTC B3843 08 is not present.

⇒	If DTC is present, replace the B108 Air Quality Sensor.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the B108 Air Quality Sensor.
2. Test for less than 5 Ω between the ground circuit terminal 2 and ground.

⇒	If greater than the specified range, test the ground circuit for an open/high resistance.

3. Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal 1 and ground.

⇒	If the test lamp does not illuminate, test the ignition circuit for a short to ground or a open/high resistance.

4. Verify the scan tool Odor Sensor parameter is greater than 95%.

⇒	If less than the specified range, test the signal circuit for a short to ground. If the circuit tests normal, replace the K33 HVAC Control Module.

5. Install a 3 A fused jumper wire between the following signal circuit terminal 3 and the ground circuit terminal 2. Verify the scan tool Odor Sensor parameter is less than 5%.

⇒	If greater than the specified range, test the signal circuit for a short to voltage or open/high resistance. If the circuit tests normal, replace the K33 HVAC Control Module.

6. If all circuits test normal, replace the B108 Air Quality Sensor.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.