GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2000 🢒 Regal (China) 🢒 Engine 🢒 Engine Electrical 🢒 Radio Replacement

Removal Procedure
  1. Remove the instrument panel (IP) cluster trim plate. Refer to Instrument Cluster Trim Panel Replacement in Instrument Panel, Gauges and Console.

    2. Object Number: 325453 Size: SH
  2. Remove the radio screws.
  3. Remove the radio from the IP.
  4. Disconnect the electrical connectors from the radio.
  5. Remove the radio.

Installation Procedure

    Object Number: 325453 Size: SH
  1. Connect the electrical connectors to the radio.

    2. Important: If the radio locator tab is difficult to align to the instrument panel (IP) locator opening, pull the radio toward you and reposition the antenna cable.

  2. Align the radio locator tab to the IP locator opening while carefully pressing the radio into the IP until fully seated.

    3. Install the radio to the IP.

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the radio screws.

    4. Tighten
    Tighten the radio screws to 2 N·m (18 lb in).

  4. Install the IP cluster trim plate. Refer to Instrument Cluster Trim Panel Replacement in Instrument Panel, Gauges and Console.