GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2000 🢒 Regal (China) 🢒 Suspension 🢒 Rear Suspension 🢒 Rear Wheel Spindle Rod Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.

    3. Object Number: 614974 Size: SH

    Important: Use a transmission jack or suitable hoist stands to prop the rear suspension support.

  3. Remove the nut (1) from the rear wheel spindle rod at the rear suspension support.

    4. Object Number: 614976 Size: SH
  4. Remove the rear wheel spindle rod to knuckle bolt and nut (2).
  5. Push the rear wheel spindle rod to knuckle bolt forward enough to provide rear wheel spindle rod removal clearance.
  6. Remove the rear wheel spindle rod.

Installation Procedure

    Object Number: 614974 Size: SH
  1. Install the rear wheel spindle rod.
  2. Install the rear wheel spindle rod to the rear suspension support bolt.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the rear wheel spindle rod to the rear suspension support nut.

    4. Tighten
    Tighten the rear wheel spindle rod to the rear suspension support nut (1) to 140 N·m (103 lb ft).

  4. Install the rear suspension support. Refer to Support Replacement .

    5. Object Number: 614976 Size: SH
  5. Connect the rear wheel spindle rod to the knuckle.
  6. Install the rear wheel spindle rod to the knuckle bolt.
  7. Install the rear wheel spindle rod to knuckle retaining nut (2).

    8. Tighten
    Tighten the rear wheel spindle rod to knuckle nut to 150 N·m (110 lb ft).

  8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  9. Lower the vehicle.
  10. Adjust the wheel toe angle. Refer to Rear Toe Adjustment in Wheel Alignment.