Tools Required
J 21177-A Drum-to-Brake
Shoe Clearance Gage
- Remove the brake caliper
bracket. Refer to
Rear Brake Caliper Bracket Replacement
in Disc Brakes.
- Remove the rotor.
Turn the rotor slowly while pulling the rotor away from the hub.
- Loosen the adjusting nut on the parking brake cable until the
lever is at the rest position.
- Set the J 21177-A
so that the J 21177-A
contacts the inside diameter of the rotor (1).
- Position the J 21177-A
over the shoe and lining at the widest
point.
- Turn the adjuster nut until the shoe and lining (1) just contacts
the J 21177-A
.
- Repeat steps two through five for the rotor on the opposite side.
- Adjust the adjusting nut on the rear parking brake cable. Refer
to
Park Brake Cable Service/Adjustment
.
- Tighten the parking brake
cable adjusting nut. Refer to
Park Brake Cable Service/Adjustment
.
- Install the rotor.
Turn the rotor slowly while sliding the rotor onto the bearing assembly.
- Install the brake caliper bracket. Refer to
Rear Brake Caliper Bracket Replacement
in Disc
Brakes.