GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Tools Required

    • Use the following tools:
    • J 25033-C Power Steering Pump Pulley Installer
    • J 37609-A Power Steering Pump Pulley Remover

    Object Number: 293353  Size: SH
  1. Remove the engine coolant recovery reservoir. Refer to Coolant Recovery Reservoir Replacement in Engine Cooling.
  2. Remove the accessory wiring junction block. Refer to Junction Block Replacement - Accessory Wiring in Body Front End.
  3. Remove the accessory drive belt. Refer to Drive Belt Replacement in Engine Mechanical.
  4. Using the J 37609-A Remove the power steering pump pulley from the power steering pump.

Installation Procedure

    Important: 

       • Never use a hammer to install the power steering pulley.
       • Do not use an arbor press to install the power steering pulley.
       • The face of the pulley hub must be flush with the end of the pump driveshaft.

  1. Using the J 25033-C Install the power steering pump pulley to the power steering pump.

  2. Object Number: 293353  Size: SH
  3. Install the accessory drive belt. Refer to Drive Belt Replacement in Engine Mechanical.
  4. Install the accessory wiring junction block. Refer to Junction Block Replacement - Accessory Wiring in Body Front End.
  5. Install the engine coolant recovery reservoir. Refer to Coolant Recovery Reservoir Replacement in Engine Cooling.