GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Tools Required

J 22610 Service Boot Clamp Installer


    Object Number: 454261  Size: SH
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tire and Wheels
  3. Remove the outer tie rod from the inner tie rod assembly. Refer to Rack and Pinion Outer Tie Rod End Replacement .

  4. Object Number: 297360  Size: SH
  5. Remove the inner tie rod jam nut (2) from the inner tie rod assembly (1).

  6. Object Number: 423441  Size: SH
  7. Remove the clamp (2) from the end of the inner tie rod boot (1).

  8. Object Number: 423443  Size: SH
  9. Remove the inner tie rod boot clamp (1) from the inner tie rod boot (3) with side cutters.
  10. Discard the inner tie rod boot clamp (1).
  11. Important: Prior to removing breather tube (2) or the inner tie rod boot (3), mark the location of the breather tube (2) on the power steering gear assembly.

  12. Remove the inner tie rod boot (3) and the breather tube (2).

Installation Procedure


    Object Number: 423443  Size: SH
  1. Install the new inner tie rod boot clamp (1) onto the inner tie rod boot (3).

  2. Object Number: 423445  Size: SH
  3. Prior to the inner tie rod boot (3) installation, apply grease to the inner tie rod assembly (2) and the power steering gear assembly (1).
  4. Install the inner tie rod boot (3) onto the inner tie rod assembly (2).
  5. Align the breather tube with the mark made during removal and the molded nipple of the inner tie rod boot.
  6. Install the inner tie rod boot (3) onto the power steering gear assembly until the inner tie rod boot (3) is seated in the power steering gear assembly groove.
  7. Important: The inner tie rod boot (3) must not be twisted, puckered or out of shape in any way. If the inner tie rod boot (3) is not shaped properly, adjust the inner tie rod boot (3) by hand before installing the boot clamp.

  8. Install the inner tie rod boot (3) onto the inner tie rod assembly (2).

  9. Object Number: 441313  Size: SH
  10. Using the J 22610 install the inner tie rod boot clamp (1) on the inner tie rod boot (2) by Firmly crimping the inner tie rod boot clamp (1).

  11. Object Number: 297638  Size: SH
  12. Install the inner tie rod jam nut (2) to the inner tie rod assembly (1).
  13. Install the outer tie rod to the inner tie rod assembly. Refer to Rack and Pinion Outer Tie Rod End Replacement .

  14. Object Number: 454261  Size: SH
  15. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tire and Wheels
  16. Lower the vehicle.
  17. Perform a front end alignment. Refer to Wheel Alignment Measurement in Wheel Alignment