Was the heater-A/C Diagnostic System Check performed?

--

Go to Step 2

Go to Diagnostic System Check

Inspect the HVAC fuse in the fuse block.

Is the HVAC fuse open?

--

Go to Step 3

Go to Step 4

Locate and repair a short to ground in circuit 41 (BRN). Refer to Testing for Short to Ground and Wiring Repairs in Wiring Systems.

Is the repair complete?

--

Go to Step 11

--

1. Place the ignition switch in the on position.
2. Connect a test lamp between the vacuum/electric solenoid harness connector terminal 6 and ground.

Does the test lamp light?

--

Go to Step 6

Go to Step 5

Locate and repair a poor connection or an open in circuit 41 (BRN). Refer to Testing for Intermittent Conditions and Poor Connections and Circuit Testing in Wiring Systems.

Is the repair complete?

--

Go to Step 11

--

1. Place the recirculation (MAX) control in the ON position.
2. Connect a test lamp between B+ and circuit 363 (TAN) at the vacuum/electric solenoid harness connector terminal 4.

Does the test lamp light?

--

Go to Step 9

Go to Step 7

Inspect for poor connection or open in circuit 363 (TAN). Refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems.

Is there a poor connection or open in the circuit?

--

Go to Step 8

Go to Step 10

Locate and repair the poor connection or open in circuit 363 (TAN). Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Is the repair complete?

--

Go to Step 11

--

There is a fault in one of the following areas:

Is the action complete?

--

Go to Step 11

--

Replace the heater-A/C control. Refer to Control Assembly Replacement .

Is the repair complete?

--

Go to Step 11

--

Verify that the system operates properly.

Does the system operate properly?

--

System OK

Go to Diagnostic System Check