Tools Required
J 41352 Modular
Column Holding Fixture
- Install the upper trim
cover (2) onto the steering column.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Screw the 2 TORX®
head screws (1) into the upper trim cover (2).
Tighten
Tighten the 2 TORX® head screws to 1.5 N·m (13 lb in).
- Install the shift lever
seal (2) onto the shift lever assembly (4).
- Install the shift lever assembly (4) onto the upper trim
cover (1).
- Install the shift lever screw (3) into the shift lever
assembly (4).
Tighten
Tighten the shift lever screw to 1.5 N·m (13 lb in).
- Slide the shift lever seal (2) down the shift lever (4).
- The shift lever seal must be seated in the trim covers.
- Install the trim protector (1)
onto the lower trim cover (2).
- Install the lower trim
cover onto the upper trim cover.
- Match the tab slots on the lower trim cover with the locking tabs
on the upper trim cover.
- Tilt the lower trim cover up.
- Slide the lower trim cover forward until the locking tabs snap
into the tab slots.
- Screw the 2 pan
head tapping screws (1) into the lower trim cover (2).
Tighten
Tighten the 2 pan head tapping screws to 3.5 N·m
(31 lb in).
- Install the tilt lever into the lower trim cover (2).
- Remove the steering column
and J 41352
from the
vise.