Important: None of the interior lights turn ON when a door is open, the IP dimmer switch is in the DOME position, or any of the interior lighting modes is active.

Did you perform the Diagnostic System Check?

--

Go to Step 2

Go to Diagnostic System Check - Lighting Systems

Inspect fuse E7-8 located in the fuse block.

Is fuse E7-8 open?

--

Go to Step 3

Go to Step 4

1. Replace fuse E7-8.
2. Open and then close any vehicle door.
3. Inspect fuse E7-8 again.

Is fuse E7-8 open again?

--

Go to Step 5

Go to Step 4

1. Inspect the BCM connector for a poor terminal contact. Perform repairs as necessary.
2. If the BCM connections are OK, replace the BCM. Refer to Body Control Module Replacement in Body Control System.

Is the repair complete?

--

Go to Step 6

--

Repair a short to ground in the following components:

Is the repair complete?

--

Go to Step 6

--

1. Turn the ignition switch to the LOCK position.
2. Reinstall the components that were removed. Reconnect the connectors.

Is the repair complete?

--

Go to Diagnostic System Check - Lighting Systems

--