Tools Required

J 39232 Wiper Transmission Separater

1. Remove the wiper arms from the vehicle. Refer to Windshield Wiper Arm Replacement .
2. Remove the air inlet grille panel from the vehicle. Refer to Air Inlet Grille Panel Replacement in Body Front End.
3. Remove the connector from the wiper motor.
4. Remove the wiper transmission from wiper motor crank arm using the J 39232 .



5. Remove three screws and the wiper drive system module from the vehicle.



6. Remove three screws and the wiper motor cover from the wiper motor.

Tools Required

J 39529 Wiper Transmission Installer

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Install the wiper motor cover on the wiper motor with three screws.

Tighten
Tighten screws to 2 N·m (18 lb in).




2. Install the wiper drive system module on the vehicle with three screws.

Tighten
Tighten screws to 10 N·m (88 lb in).




3. Install the wiper transmission on the wiper motor crank arm using the J 39529 .
4. Install the connector to the wiper motor.
5. Install the air inlet grille panel on the vehicle. Refer to Air Inlet Grille Panel Replacement in Body Front End.
6. Install the wiper arms on the vehicle. Refer to Windshield Wiper Arm Replacement .
7. Operate the wipers and inspect for proper operation.