GM Service Manual Online
For 1990-2009 cars only

Step

Action

Value(s)

Yes

No

1

Was the Wiper/Washer System Check performed?

--

Go to Step 2

Go to Wiper/Washer System Check

2

Inspect the washer solvent container fluid level.

Is the washer solvent container filled?

--

Go to Step 4

Go to Step 3

3

Fill the washer solvent container.

Is the washer solvent container filled?

--

Go to Wiper/Washer System Check

--

4

Inspect the hoses to ensure that they are correctly attached and that they are not pinched or kinked.

Are the hoses OK?

--

Go to Step 6

Go to Step 5

5

Repair the hoses.

Is the repair complete?

--

Go to Wiper/Washer System Check

--

6

Inspect for clogged windshield washer nozzles.

Are the nozzles clogged?

--

Go to Step 7

Go to Step 8

7

Clear the clogged nozzles.

Are the nozzles clear?

--

Go to Wiper/Washer System Check

--

8

Inspect for an open wiper fuse.

Is the fuse open?

--

Go to Step 9

Go to Step 10

9

Replace the open fuse.

Is the replacement complete?

--

Go to Wiper/Washer System Check

--

10

  1. Disconnect the washer pump connector.
  2. Turn the ignition switch to ON.
  3. Connect a J 35616-200 between terminals A and B of the washer pump connector (harness side).
  4. Activate the washer switch while observing the test light.

Is the test light on?

--

Go to Step 11

Go to Step 14

11

Inspect for a poor connection at the washer pump connector.

Is a poor connection present?

--

Go to Step 12

Go to Step 13

12

Repair the poor connection.

Is the repair complete?

--

Go to Wiper/Washer System Check

--

13

Replace the washer pump. Refer to Washer Pump Replacement .

Is the replacement complete?

--

Go to Wiper/Washer System Check

--

14

  1. Connect the J 35616-200 between the washer pump connector (harness side), terminal A, and ground.
  2. Activate the washer switch while observing test light.

Is the test light on?

--

Go to Step 15

Go to Step 16

15

Repair the poor connection or open in CKT 1450.

Is the repair complete?

--

Go to Wiper/Washer System Check

--

16

  1. Backprobe the wiper/washer switch connector, terminal E4, to ground using a J 35616-200 .
  2. Activate the washer switch.

Is the test light on?

--

Go to Step 18

Go to Step 17

17

Repair the poor connection or open in CKT 228.

Is the repair complete?

--

Go to Wiper/Washer System Check

--

18

Replace the wiper/washer switch . Refer to Multifunction Turn Signal Lever Replacement - On Vehicle in Steering Wheel and Column - Tilt.

Is the replacement complete?

--

Go to Wiper/Washer System Check

--