For 1990-2009 cars only
Removal Procedure
- Disconnect the evaporative emission (EVAP) purge hose from the purge line near the throttle body. Refer to Plastic Collar Quick Connect Fitting Service .
- Remove the EVAP purge hose from the retainer.
- Remove the EVAP purge pipe from the intake manifold.
- Remove the EVAP purge hose from the EVAP purge valve and the intake manifold.
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Disconnect the EVAP purge from the fuel tank.
- Disconnect the EVAP purge pipe from the fuel pipe retainers.
- Remove the EVAP purge pipe from the vehicle.
Installation Procedure
- Install the EVAP purge pipe from the vehicle.
- Install the EVAP purge pipe to the retainers.
- Connect the chassis EVAP purge pipe to the fuel tank.
- Lower the vehicle.
- Install the EVAP purge hose to the EVAP purge valve and the intake manifold.
- Install the EVAP purge pipe to the intake manifold.
- Install the EVAP purge hose to the retainer.
- Connect the EVAP hose to the purge line near the throttle body. Refer to Plastic Collar Quick Connect Fitting Service .
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the EVAP purge hose bracket bolt to 10 N·m
(89 lb in).
