Removal Procedure
- Remove the front seats. Refer to
Bucket Seat Replacement
in Seats.
- Remove the floor console bracket. Refer to
Floor Console Bracket Replacement
in Instrument Panel, Gages and Console.
- Lift and reposition the front carpet.
- Remove the center floor duct nuts.
- Separate the center floor duct from the HVAC module.
- Separate the center floor duct from the rear floor duct.
- Remove the center floor duct.
Installation Procedure
- Install the center floor duct.
- Connect the center floor duct to the rear floor duct.
- Connect the center floor duct to the HVAC module.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the center floor duct nuts.
Tighten
Tighten the floor duct nuts to 10 N·m (89 lb in).
Important: The rear floor air outlet ducts must be aligned with the corresponding holes in the front carpet.
- Reposition the front carpet back into position.
- Install the console bracket. Refer to
Floor Console Bracket Replacement
in Instrument Panel, Gages and Console.
- Install the front seats. Refer to
Bucket Seat Replacement
in Seats.