For 1990-2009 cars only
Removal Procedure
- Remove the wiper arms. Refer to Windshield Wiper Arm Replacement .
- Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
- Remove the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement in Wiring Systems.
- Remove the cruise control module. Refer to Cruise Control Module Replacement in Cruise Control.
- Disconnect the wiper motor cover electrical connector.
- Remove the wiper system drive module bolts.
- Remove the wiper system drive module from the engine compartment.
Installation Procedure
- Position the wiper system drive module to the cowl.
- Install the wiper system drive module bolts.
- Connect the wiper motor cover electrical connector.
- Install the cruise control module and bracket. Refer to Cruise Control Module Replacement in Cruise Control.
- Install the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement in Wiring Systems.
- Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
- Install the wiper arms. Refer to Windshield Wiper Arm Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 9 N·m (80 lb in).
