Parking and Turn Signal Lamp Replacement Rendezvous

1. Open the hood.
2. Remove the front parking/sidemarker lamp socket, depressing the locking tab and turning counterclockwise.



3. Remove the bulb from the front parking/sidemarker lamp socket, if replacing the bulb.

1. Install the bulb to the front parking/sidemarker lamp socket, if replacing the bulb.



2. Install the front parking/sidemarker lamp socket, turning the socket clockwise until the locking tab is fully seated.
3. Close the hood.

Parking and Turn Signal Lamp Replacement Aztek

1. Open the hood.
2. Remove the screws from the front parking/sidemarker lamp.



3. Disconnect the front parking/sidemarker lamp wiring harness from the pinch-weld flange.



4. Remove the front parking/sidemarker lamp from the front fender.



5. Remove the front parking/sidemarker lamp socket, depressing the locking tab and turning counterclockwise.



6. Remove the bulb from the front parking/sidemarker lamp socket, if replacing the bulb.

1. Install the bulb to the front parking/sidemarker lamp socket, if replacing the bulb.



2. Install the front parking/sidemarker lamp socket, turning the socket clockwise until the locking tab is fully seated.



3. Connect the front parking/sidemarker lamp wiring harness to the pinch-weld flange.



4. Align the ball stud of the front parking/sidemarker lamp to the grommet in the fender reinforcement.



5. Position the alignment pins of the front parking/sidemarker lamp to the to the holes in the fender reinforcement.



6. Install the front parking/sidemarker lamp to the front fender, pressing into place until fully seated.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

7. Install the screws to the front parking/sidemarker lamp.

Tighten
Tighten the front parking/sidemarker lamp screws to 2 N·m (18 lb in).

8. Close the hood.