Rear Wheel Opening Molding Replacement for Buick Rendezvous - FWD 2003

1. Remove the screws from the rear wheel opening molding.
2. Pull the upper edge of the rear wheel opening molding out, to release the retainers.
3. A thin, plastic flat-bladed tool may be used between the molding and the body to help release the wheel opening molding retainers.
4. Remove the rear wheel opening molding from the vehicle.

1. Position the rear wheel opening molding to the rear quarter panel.
2. Align the wheel opening molding retainers to the holes in the rear quarter panel.
3. Press the molding to the rear quarter panel until all of the retainers are fully seated.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the wheel opening molding screws.

Tighten
Tighten the wheel opening molding screws to 2 N·m (18 lb in).