Position the lower flange of the rear body panel molding to the hem flange
of the endgate, pulling upward and forward to align the retainer clips to the holes
in the endgate.
Important: Do not touch the adhesive backing on the molding.
Remove the protective liner from the back side of the rear body panel molding.
Position the upper edge of the rear body panel molding retainer clips
to the holes in the endgate.
Install the retainer clips to the endgate by pressing in until fully
seated.
Install the upper edge of the rear body panel molding by applying pressure
to the entire length of the molding starting at the center and working outward in
order to ensure a maximum bond to the endgate.