Caution:  When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

1. Open the endgate.

Notice: Apply pressure only at the end of the liftgate/hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod because damage or bending will result.

2. Lift up the retainer clips on the endgate assist rods using a small flat-bladed tool.



3. Remove the upper end of the assist rods from the ball joint.



4. Remove the lower end of the assist rods from the ball joint.



5. Remove the assist rods from the endgate.

1. Position the assist rods to the endgate.



2. Install the upper end of the assist rods to the ball joint. Press in to place until fully seated.



3. Install the lower end of the assist rods to the ball joint. Press in to until fully seated.
4. Close the endgate.