Removal Procedure
- Turn the ignition OFF.
Important: Do not disconnect the power steering fluid
lines/hoses from the reservoir.
- Remove the power steering fluid reservoir bolts and reposition the power steering
fluid reservoir in order to provide access. Refer to
Remote Power Steering Fluid Reservoir Replacement
in Power Steering System.
- Disconnect the camshaft position (CMP) actuator
valve electrical connector (2).
- Remove the CMP actuator valve bolt.
- Remove the CMP actuator valve.
Installation Procedure
- Install the CMP actuator valve.
Notice: Refer to Fastener Notice in the Preface section.
- Install the CMP actuator valve bolt.
Tighten
Tighten the CMP actuator valve bolt to 10 N·m
(89 lb in).
- Connect the CMP actuator valve
electrical connector (2).