Removal Procedure
Caution: Refer to Battery Disconnect Caution in the Preface section.
Caution: Batteries generate hydrogen gas, which is extremely flammable and may
explode violently if ignited by a spark or a flame. Battery acid is extremely
corrosive and causes severe personal injury if the acid comes into contact
with the skin, and blindness if the acid comes into contact with the eyes.
In order to avoid severe personal injury, use extreme caution
when servicing the battery or battery-related components.
- Disconnect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
.
- If equipped with regular production option (RPO) LX9, perform the following steps. Loosen the positive battery cable bolt at the battery.
- Remove the positive battery cable from the battery.
- Remove the front fender diagonal brace. Refer to
Front End Sheet Metal Diagonal Brace Replacement - Right Side
.
- Remove the battery hold down retainer bolt and retainer.
Important: Do not tip the battery more than 40 degrees.
- Remove the battery.
- If equipped with RPO LY7, perform the following steps. Loosen the positive battery cable nut at the battery.
- Remove the positive battery cable from the battery.
- Remove the front fender diagonal brace. Refer to
Front End Sheet Metal Diagonal Brace Replacement - Right Side
.
- Remove the battery hold down retainer bolt and retainer.
Important: Do not tip the battery more than 40 degrees.
- Remove the battery.
- Remove the battery insulator from the battery. (RPO LY7 shown, RPO LX9 similar).
Installation Procedure
- Install the battery insulator to the battery. (RPO LY7 shown, RPO LX9 similar).
Important: Do not tip the battery more than 40 degrees.
- If equipped with RPO LY7, perform the following steps. Install the battery.
Notice: Refer to Fastener Notice in the Preface section.
- Install the battery hold down retainer and bolt.
Tighten
Tighten the bolt to 17 N·m (13 lb ft).
- Install the front fender diagonal brace. Refer to
Front End Sheet Metal Diagonal Brace Replacement - Right Side
.
- Install the positive battery cable to the battery.
- Tighten the positive battery cable nut at the battery.
Tighten
Tighten the nut to 16 N·m (12 lb ft).
Important: Do not tip the battery more than 40 degrees.
- If equipped with RPO LX9, perform the following steps. Install the battery.
- Install the battery hold down retainer and bolt.
- Install the front fender diagonal brace. Refer to
Front End Sheet Metal Diagonal Brace Replacement - Right Side
.
- Position the positive battery cable to the battery.
- Tighten the positive battery cable bolt at the battery.
Tighten
Tighten the bolt to 16 N·m (12 lb ft).
- Connect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
.