Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Instrument Cluster Schematics | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 |
Does the Engine Oil Level Switch parameter display OK? | Go to Step 3 | Go to Step 4 |
3 | Does the low engine oil level indicator remain illuminated after the displays test? | Go to Step 10 | Go to Testing for Intermittent Conditions and Poor Connections |
4 |
Does the test lamp illuminate? | Go to Step 7 | Go to Step 5 |
5 | Test the signal circuit of the engine oil level indicator switch for an open, or for a short to voltage. Refer to Circuit Testing and to Wiring Repairs . Did you find and correct the condition? | Go to Step 12 | Go to Step 6 |
6 | Test the ground of the engine oil level indicator switch for an open. Refer to Circuit Testing and to Wiring Repairs . Did you find and correct the condition? | Go to Step 12 | Go to Step 8 |
7 | Inspect for poor connections at the ECM/PCM. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs . Did you find and correct the condition? | Go to Step 12 | Go to Step 9 |
8 | Inspect for poor connections at the engine oil level switch. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs . Did you find and correct the condition? | Go to Step 12 | Go to Step 11 |
9 | Replace the ECM/PCM. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | Go to Step 12 | -- |
10 | Replace the IPC. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | Go to Step 12 | -- |
11 | Replace the engine oil level switch. Refer to Engine Oil Pressure Sensor and/or Switch Replacement for the 3.6L (LY7) engine. Did you complete the replacement? | Go to Step 12 | -- |
12 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 2 |
