GM Service Manual Online
For 1990-2009 cars only

Cruise Control Indicator Inoperative 3.6L

Step

Action

Yes

No

Schematic Reference: Cruise Control Schematics

Connector End View Reference: Lighting Systems Connector End Views

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

2

  1. Turn the ignition OFF.
  2. Install a scan tool.
  3. Turn the ignition ON, with the engine OFF.
  4. With the scan tool, command the Cruise Control Lamp Test parameter On, in the instrument panel cluster (IPC) Special Functions.

Does the Cruise indicator illuminate in the IPC?

Go to Step 4

Go to Step 3

3

Replace the IPC. Refer to Instrument Cluster Replacement in Instrument Panel, Gages, and Console.

Did you complete the replacement?

Go to Step 5

--

4

Replace the powertrain control module (PCM). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 5

--

5

Operate the system in order to verify the repair.

Does the system operate properly?

System OK

Go to Step 2

Cruise Control Indicator Inoperative non 3.6L

Step

Action

Yes

No

Schematic Reference: Cruise Control Schematics

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

2

  1. Install a scan tool.
  2. With a scan tool, command the cruise control indicator ON.

Does the cruise control indicator illuminate?

Go to Step 3

Go to Step 4

3

Inspect for poor connections at the harness connector of the powertrain control module (PCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 7

Go to Step 5

4

Inspect for poor connections at the harness connector of the instrument panel cluster (IPC). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 7

Go to Step 6

5

Replace the PCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you find and correct the condition?

Go to Step 7

--

6

Replace the IPC. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the repair?

Go to Step 7

--

7

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2