GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2006 🢒 Rendezvous - FWD 🢒 Vehicle Control Systems 🢒 Vehicle DTC Information 🢒 Manifold Absolute Pressure Sensor Replacement

Removal Procedure

    Object Number: 1641076 Size: SH
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Disconnect the fuel injector harness electrical connector from the manifold absolute pressure (MAP) sensor.

    3. Object Number: 1641082 Size: SH
  3. Remove the MAP sensor bolt/stud and bracket.
  4. Remove the MAP sensor and the MAP sensor port seal if it is still retained in the intake manifold.

Installation Procedure

    Object Number: 1641082 Size: SH
  1. Install the MAP sensor to the intake manifold.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the MAP sensor bracket and bolt/stud.

    3. Tighten
    Tighten the bolt to 10 N·m (89 lb in).


    Object Number: 1641076 Size: SH
  3. Connect the fuel injector harness electrical connector to the MAP sensor.
  4. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .