Tools Required

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the wheel and tire assemblies. Refer to Tire and Wheel Removal and Installation .



3. Use a utility stand in order to support the lower control arm.



4. Remove the coil spring (2). Refer to Coil Spring Replacement .



5. Make a mark on the lower control arm at the cam indicator (1).



6. Remove the lower control arm to crossmember mounting bolts (1, 5) .




Important: Identify the orientation of the voids in the bushing to the crossmember.

7. Remove the bushing from the crossmember.



8. In order to remove the bushing from the crossmember, use the following tools from the J 21474-01 :

•	J-6627-4 (1)

•	J-45411 (2)

•	J-21474-8 (3)

•	J-21474-4 (4)

Important: Install the new bushing to the crossmember in the same mannerism as/was the old bushing noting the voids.

1. Use the J 21474-01 in order to install the bushing to the crossmember.





2. Install the lower control arm and mounting bolts  (1, 5) to the crossmember. Refer to Rear Axle Lower Control Arm Replacement .



3. Line up the mark on the lower control arm at the cam indicator (1) .



4. Install the coil spring (2). Refer to Coil Spring Replacement .
5. Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
6. Inspect the rear camber and toe angles and adjust as necessary. Refer to Rear Camber Adjustment and Rear Toe Adjustment .
7. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .