Front Side Door Trim Panel Replacement Rendezvous

Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover

1. Open the door.
2. Disconnect the power window switch assembly. Refer to Front Side Door Window Switch Replacement - Left Side or to Front Side Door Window Switch Replacement - Right Side .
3. Remove the screws from the front door trim panel
4. Use the J 38778 to remove the trim panel.

4.1.	Reposition the electrical harness connectors.

4.2.	Remove the trim panel from the vehicle.

Important: Before installing the front door trim panel, discard the old trim panel retainers and replace with NEW trim panel retainers.

1. Install the new retainers to the front door trim panel.
2. Route the electrical connectors through the trim panel.
3. Align the trim panel to the door inner panel, guiding the door handle through the trim panel.
4. Install the upper edge of the trim panel to the top edge of the inner door panel, pressing down firmly until the trim panel is fully seated.
5. Install the trim panel by firmly pressing the retainer clips until the clips are fully seated around the perimeter of the trim panel.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

6. Install the screws to the front door trim panel.

Tighten
Tighten the screws to 2 N·m (18 lb in).

7. Connect the power window switch. Refer to Front Side Door Window Switch Replacement - Left Side or to Front Side Door Window Switch Replacement - Right Side .