Console Rear Trim Plate Replacement Rendezvous

1. Open the armrest.
2. Remove the two screws that hold the trim plate.



3. Pull on the trim plate to release the clips.
4. Disconnect the trim plate electrical connections.
5. Remove the trim plate.

1. Connect the electrical connections.
2. Press the trim plate to the console until the plate is fully seated.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the trim plate screws.

Tighten
Tighten the screws to 2 N·m (18 lb in).

4. Close the armrest.