Assist Handle and Rear Coat Hook Replacement Rendezvous

1. Rotate the assist handle downward.
2. Remove the screws from the handle assembly.
3. Remove the bulb socket assembly from the lamp assembly.
4. Disconnect the electrical connectors.
5. Remove the assist handle assembly.

1. Connect the electrical connectors.
2. Install the bulb socket in the lamp assembly.
3. Position the pull handle.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the screws to the assist handle and coat hook.

Tighten
Tighten the screws to 3 N·m (27 lb in).