Transmission Mount Bracket Replacement - Left Side LY7

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the right front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
3. Remove the right engine splash shield. Refer to Engine Splash Shield Replacement in Body Front End.
4. Remove the transfer case brace. Refer to Support Brace Replacement in Transfer Case - Steyr.



5. Remove the transmission lower brace bolts.
6. Remove the transmission lower brace.
7. If you are servicing the transmission upper brace, perform the following steps.



8. Remove the transmission upper brace nut located behind the power steering pump.
9. Disconnect the intermediate steering shaft from the steering gear. Refer to Intermediate Steering Shaft Replacement in Steering Wheel and Column.
10. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.



11. Use a utility stand in order to support the center of the rear frame.
12. Remove only the two frame rear bolts.
13. Raise the vehicle or lower the powertrain in order to access the transmission upper brace.



14. Remove the transmission upper brace bolts.
15. Remove the transmission upper brace.

1. Install the transmission upper brace.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the transmission upper brace bolts.

Tighten
Tighten the transmission upper brace outboard bolts (2) to 23 N·m (17 lb ft).

Tighten
Tighten the transmission upper brace inboard bolt (1) to 50 N·m (37 lb ft).

3. Lower the vehicle or raise the powertrain until the frame insulators contact the chassis.
4. Install the two frame rear bolts. Refer to Front Frame Replacement in Frame and Underbody.
5. Connect the intermediate steering shaft to the steering gear. Refer to Intermediate Steering Shaft Replacement in Steering Wheel and Column.



6. Install the transmission upper brace nut located behind the power steering pump.

Tighten
Tighten the transmission upper brace nut to 50 N·m (37 lb ft).




7. Install the transmission lower brace.
8. Install the transmission lower brace bolts.

Tighten
Tighten the transmission lower brace bolts to 50 N·m (37 lb ft).

9. Install the transfer case brace. Refer to Support Brace Replacement in Transfer Case - Steyr.
10. Install the right engine splash shield. Refer to Engine Splash Shield Replacement in Body Front End.
11. Install the right front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
12. Lower the vehicle.