For 1990-2009 cars only
- Open the hood. See Hood Release for more information.
- Push in on the headlamp panel and lift up the headlamp retaining clip partway, but do not remove.
- Remove the wing stud on the upper, outboard side of the lamp assembly.
- Unsnap the headlamp assembly by pulling it forward, away from the vehicle.
- Disconnect the electrical connector by pulling back on the locking tab, located on the electrical connector, to separate the two connectors.
- Pull the bulb assembly out from the lamp housing.
- Unhook the electrical connector by lifting up the gray tabs and separate the connector from the bulb base.
- Install the appropriate new bulb into the electrical connector. Push the bulb firmly enough so that the gray tabs hook over the tab on the bulb.
- Put the bulb assembly back into the lamp housing and turn the bulb socket one-quarter of a turn counterclockwise.
- Align the retaining clips on the back of the headlamp with the rectangular holes in the mounting panel.
- Push firmly on both ends of the headlamp to snap it into position.
- Push the retaining clip down to its original position.
- Reinstall the wing stud.
Turn the bulb socket one-quarter of a turn clockwise.
