1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Disconnect the engine harness electrical connector (2) from the left knock sensor.



3. Remove the knock sensor.

Notice: Refer to Fastener Notice in the Preface section.

Important:  DO NOT apply thread sealant to the sensor threads. The sensor threads are coated at the factory. Applying additional sealant affects the sensors ability to detect detonation.

1. Install the knock sensor.

Tighten
Tighten the sensor to 25 N·m (18 lb ft).




2. Connect the engine harness electrical connector (2) to the left knock sensor.
3. Lower the vehicle.