Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

1. Install a scan tool.
2. Turn the ignition ON, with the engine OFF.
3. With a scan tool, command the body control module (BCM) Horn Output ON and OFF.

Is the horn on at all times?

Go to Step 3

Go to Testing for Intermittent Conditions and Poor Connections

1. Turn OFF the ignition.
2. Disconnect the horn relay.

Is the horn on at all times?

Go to Step 8

Go to Step 4

4

Connect a test lamp between the battery positive voltage circuit of the horn relay coil and the horn relay control circuit.

Does the test lamp illuminate?

Go to Step 5

Go to Step 6

5

Important: The horn switch is part of the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement .

1. To disable the SIR system, refer to SIR Disabling and Enabling.
2. Test the horn relay control circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs.

Did you find and correct the condition?

Go to Step 11

Go to Step 7

Inspect for poor connections at the horn relay. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs.

Did you find and correct the condition?

Go to Step 11

Go to Step 9

Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs.

Did you find and correct the condition?

Go to Step 11

Go to Step 10

Repair the short to voltage in the horn control circuit. Refer to Circuit Testing and Wiring Repairs.

Did you complete the repair?

Go to Step 11

--

Replace the horn relay.

Did you complete the replacement?

Go to Step 11

--

Replace the BCM. Refer to Control Module References.

Did you complete the replacement?

Go to Step 11

--

Operate the horn.

Does the horn operate properly?

System OK

Go to Step 1