Removal Procedure
- Remove the I/P compartment. Refer to Instrument Panel Compartment Replacement .
- Disconnect and remove the right hand temperature door lever spring (2).
- Disconnect and remove the right hand temperature lever (1) from the right hand temperature door.
- Disconnect the right hand temperature actuator electrical connector.
- Remove the right hand temperature actuator mounting screws.
- Remove the right hand temperature actuator.
Installation Procedure
- Install the right hand temperature actuator.
- Install the right hand temperature actuator mounting screws.
- Connect the right hand temperature actuator electrical connector.
- Install the right hand temperature lever (1) to the right hand temperature door.
- Connect the right hand temperature door lever spring (2) to the right hand temperature door lever (1) and HVAC module case.
- Install the I/P compartment. Refer to Instrument Panel Compartment Replacement.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 1.6 N·m (14 lb in).
Important: Align the pin on the right hand air temperature actuator with the slot in the right hand temperature door lever.
