GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2007 🢒 Rendezvous - FWD 🢒 Diagnostic Navigation 🢒 Programming and Setup 🢒 Console Electrical Center or Junction Block Replacement

Removal Procedure
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the front floor console. Refer to Front Floor Console Replacement .

    3. Object Number: 627732 Size: SH
  3. Disconnect the electrical connectors (1, 2, 3) from the body control module (BCM).

    4. Object Number: 627975 Size: SH
  4. Disconnect the electrical connectors (1, 2) from the console accessory wiring junction block.

    5. Object Number: 627736 Size: SH
  5. Release the retainers (1) from the junction block.
  6. Remove the junction block (2) from the bracket.

Installation Procedure

    Object Number: 627736 Size: SH
  1. Install the console accessory wiring junction block (2) into the bracket.
  2. Secure the junction block retainers (1).

    3. Object Number: 627975 Size: SH
  3. Connect the electrical connectors (1, 2) to the junction block.

    4. Notice: Refer to Fastener Notice in the Preface section.

  4. Install the electrical connectors bolts (1, 2) to the junction block. Finger tighten the bolts until seated.

    5. Tighten
    Tighten the bolts to 6 N·m (54 lb in).


    Object Number: 627732 Size: SH
  5. Connect the BCM electrical connectors (1, 2, 3).
  6. Install the front floor console. Refer to Front Floor Console Replacement .
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .