GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2007 🢒 Rendezvous - FWD 🢒 HVAC 🢒 HVAC - Manual 🢒 Blower Motor Resistor Assembly Replacement

Removal Procedure
  1. Remove the right side instrument panel insulator. Refer to Instrument Panel Insulator Panel Replacement - Right Side.

    2. Object Number: 295327 Size: SH
  2. Disconnect the blower motor electrical connector.
  3. Remove the blower motor mounting screws.
  4. Remove the blower motor from the HVAC module assembly.

    5. Object Number: 295302 Size: SH
  5. Disconnect the electrical connector from the blower motor resistor assembly.

    6. Important: Only loosen both of the forward blower resistor assembly mounting screws. The blower motor resistor assembly mounting holes are slotted.

  6. Loosen the forward blower resistor assembly mounting screws.
  7. Remove the rearward blower resistor assembly mounting screw.

    8. Object Number: 295304 Size: SH
  8. Remove the blower motor resistor assembly from the HVAC module assembly.

Installation Procedure

    Object Number: 295304 Size: SH
  1. Install the blower motor resistor assembly to the HVAC module assembly.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the rearward blower resistor assembly mounting screw.

    3. Tighten
    Tighten all of the screws to 1.8 N·m (16 lb in).


    Object Number: 295302 Size: SH
  3. Connect the electrical connector to the blower motor resistor assembly .
  4. Install the blower motor to the HVAC module assembly.
  5. Install the blower motor mounting screws.

    6. Tighten
    Tighten the screws to 1.8 N·m (16 lb in).


    Object Number: 295327 Size: SH
  6. Connect the blower motor electrical connector.
  7. Install the right side instrument panel insulator. Refer to Instrument Panel Insulator Panel Replacement - Right Side.