TORQUE ROD ADJUSTMENT SERVICE PROCEDURE

SHOULD IT BECOME NECESSARY TO ADJUST THE TORQUE RODS ON A LATE MODEL RIVIERA THE FOLLOWING PROCEDURE MAY BE USED... 1. REMOVE THE REAR COMPARTMENT LID AND REAR COMPARTMENT FRONT PANEL AS OUTLINED IN SECTION 7, PAGE 7-9 OF THE 1983 FISHER SERVICE MANUAL. 2. USING VICE GRIP PLIERS (SEE FIGURE 1) DISENGAGE LEFT TORQUE ROD END FROM RIGHT HINGE ASSEMBLY. 3. REPOSITION LEFT END OF TORQUE ROD IN UPPER LOCATION AND REENGAGE END OF TORQUE ROD IN RIGHT HINGE ASSEMBLY. 4. REPEAT STEPS 2 AND 3 ON RIGHT TORQUE ROD, LEFT HINGE. 5. INSTALL DECK LID AND CHECK FOR PROPER OPERATION.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.