REAR TAIL LIGHT BULB REPLACEMENT

THE FOLLOWING REAR TAIL LIGHT BULB REPLACEMENT PROCEDURE SUPERSEDES THE ONE PRINTED ON PAGE 8A-93 OF THE 1981 SKYLARK SERVICE MANUAL. 1.REMOVE PLASTIC CLIP FROM CENTER BUMPER FILLER TO INTERMEDIATE BUMPER FILLER. 2.REMOVE PHILLIPS HEAD SCREW FROM BUMPER FILLER TO TAIL LIGHT HOUSING (ACCESSIBLE FROM UNDERNEATH). 3.OPEN TRUNK LID. 4.REMOVE (4) WING NUTS INSIDE TRUNK, AT REAR OF EACH TAIL LIGHT ASSEMBLY. 5.PULL TAIL LIGHT OUTWARD TO ALLOW ACCESS TO LIGHT SOCKETS. 6.UNSNAP THE WIRING HARNESS RETAINER CLIPS SHOWN ON PAGE 8A-43, FIGURE 2 OF 1981 SERVICE MANUAL. 7.REMOVE BULB SOCKET(S). 8.REMOVE BULB(S). 9.REVERSE PROCEDURES FOR INSTALLATION.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.